Regional Centre for Innovation and Technology Transfert
Specialised in Adhesive Bonding
The structure
TECHNACOL is an equipped associative structure.
It also makes use of the Research Laboratories belonging to the Ecole Nationale d'Ingénieurs ( National Engineering School) in Tarbes, in the South of France.
Six people are employed and work in collaboration with the Engineering school professors.
Fields of activity
Adhesive Bonding
All materials- From Design to Manufacture
- Calculation and dimensioning of adhesive bonds
- Surface preparation selection
- Choice of adhesives and their processing
- Bonding characterisation (ageing, mechanical testing, nondestructive testing, …)
- Definition of control tests and procedures
- Development of pilot units
- Pre-series, prototypes
Return to the top
Services
- Assistance
- Feasability studies
- Testing
- Expert appraisals
- Funding studies
- Training
Activity sectors
All sectors using adhesives and requiring solutions.
Return to the top
Technical methods
Design : E ngineering office equipped with most industrial software.
Measurement of surface characteristics :
Goniometer, Atomic force microscope, 3D roughness meter.
Adhesive characterisation :
Rheometer, D.S.C/ TMA, Infrared.
Bonding characterisation : Mechanical analysers
with thermical enceinte (tensile load, compression, flexion, fatigue…), Ultrasonic inspection..
Ageing : Hydrothermal, Salt spray, UV irradiation.
Processing material :
Air powered dispense system, micrometric applicator, Hot melt applicators, programmable vacuum oven, UV cure system, Microwave, Heated press.
Surface treatements:
Sand blast machine, Polishing machine, Corona effect, flame treatment, Supersonic chamber, Chemical and electro-chemical treatments.
Customers
- ALSTOM
- EADS
- GAZ DE FRANCE
- SCHLUMBERGER
- SNECMA TURBOMECA
- SCHNEIDER ELECTRIC
- SIEMENS AUTOMOTIVE
Some technical projects
- PC light-ports bonded on the composite structure of JL. Etienne's Polar Observer.
- Acryl /ABS washbasin bonded to a fibreboard layered toilet surface.
- Optimization of oxygen sensor molding.
- Bonding of neoprene foam for skin diving.
- Ageing of gaz transport multilayer tubes.
- Bonding of metal and ceramic heat exchangers.
Return to the top
